-
Table top front loading Autoclave.
-
Fully Automatic Micro-Processor based Control.
-
Highly accurate Semiconductor pressure sensor for 1.2kg.(1210C) or 2kg (134 C)
-
Sterilisation Chamber made up of thick stainless steel sheet, tested with high pressure.
-
Digital Timer both for wet and dry heat: Wet Timer starts after desired
-
temperature is reached irrespective of load of instruments in Chamber.
-
Dry Timer starts automatically after wet cycle is over, resulting in perfect sterilization.
-
Silicone Rubber ring-gasket in the door, silicon tube for Drain water.
-
Screw Handle for door locking prevents sudden opening of door.
-
Auto drain of water and also condensation of steam.
-
Alarm after total command is over.
-
Auto equaliser of pressure in Chamber for easy opening.
-
Finished with heat cured Epoxy powder coating paint.
-
Base and Front Panel made of stainless steel.
-
Highly Accurate Motorol Pressure Sensor is used (PT-100).
-
Tone Buzzer to produce different tones during operation. (viz., Key press, Temperature reached, Job over etc. )
-
Wet Heater to a maximum of 1.0kW.
-
Dry Heater to a maximum of 300W.
-
Thermostat for sensing no water in the sterilization chamber.
-
Programmed parameters are stored in Flash memory, eliminating the need to set
-
the parameters again after Power Off.
